What it is
Belotero Revive is an injectable, resorbable implant of cross-linked sodium hyaluronate of non-animal origin, with glycerol, produced with CPM technology. It is lidocaine-free.
Intended use (per instructions for use)
Intended to revitalise facial skin by rehydrating dry and very dry skin, increasing elasticity and firmness and smoothing superficial fine lines. Indicated for revitalising prematurely sun-damaged skin of the cheeks, characterised by dehydration, loss of elasticity and firmness and superficial fine lines. According to the manufacturer's clinical data, the product has been shown to last up to 9 months. The purpose of the product is purely aesthetic; no clinical benefits can be expected.
Composition
Sodium hyaluronate 20 mg/ml, glycerol 17.5 mg/ml, phosphate buffer pH 7 q.s. 1.0 ml. Residual BDDE ≤ 2 ppm.
Treatment
- Contents: 1 pre-filled 1 ml syringe and 2 sterile single-use 30G½″ needles.
- Injection: mid or deep dermis. The recommended technique is serial micropuncture with approximately 50 µl per point, 20–30 points approximately 1–2 cm apart. Inject slowly, aspirate before injecting and avoid overcorrection. See the instructions for use for maximum volume and interval.
Important to know
For injection only by healthcare professionals with training and knowledge of the anatomy. Contraindicated in case of known hypersensitivity to the constituents (including sodium hyaluronate, glycerol or BDDE), in pregnant or breastfeeding women, under 18 years of age, in case of general infection and in active autoimmune disease. Do not inject into blood vessels, into the glabella or nose area, into skin with active inflammation or infection, or into areas previously treated with a permanent skin filler. Rare but serious events have been reported after unintentional injection into facial blood vessels (including vision impairment, blindness, stroke and skin necrosis). Single-use device; do not re-sterilise or reuse.
Storage and shelf life
Store at 2–25 °C, protected from light and dry. Avoid mechanical shocks. Do not freeze. Check the packaging and expiry date before use.
Documentation and traceability
CE-marked (CE 0123). Manufacturer: Anteis SA, Plan-les-Ouates, Switzerland. Authorised representative in the EU: Merz Aesthetics GmbH, Frankfurt am Main, Germany. See the attached Norwegian instructions for use (version 4.0, 23.02.2026).
